Features
˙Popular T-1 3/4 round package.
|
˙High efficiency.
|
˙Built in red, yellow, and green chips.
|
˙Selected minimum intensities.
|
˙Available on tape and reel.
|
˙The product itself will remain within RoHS compliant version
|
Descriptions
˙The series is specially designed for applications requiring higher brightness
|
˙The LED lamps are available with different colors, intensities, epoxy, colors, etc.
|
Applications
˙Status indicators.
|
˙Commercial use.
|
˙Advertising Signs.
|
˙Computer
|
Notes
1. Lead Forming
During lead formation, the leads should be bent at a point at least 3mm from the base of the epoxy bulb.
Lead forming should be done before soldering.
Avoid stressing the LED package during leads forming. The stress to the base may damage the LED’s characteristics or it may break the LEDs.
Cut the LED leadframes at room temperature. Cutting the leadframes at high temperatures may cause failure of the LEDs.
When mounting the LEDs onto a PCB, the PCB holes must be aligned exactly with the lead position of the LED. If the LEDs are mounted with stress at the leads, it causes deterioration of the epoxy resin and this will degrade the LEDs.
2. Storage
The LEDs should be stored at 30°C or less and 70%RH or less after being shipped from Everlight and the storage life limits are 3 months. If the LEDs are stored for 3 months or more, they can be stored for a year in a sealed container with a nitrogen atmosphere and moisture absorbent material.
Please avoid rapid transitions in ambient temperature, especially, in high humidity environments where condensation can occur.
3. Soldering
Careful attention should be paid during soldering. When soldering, leave more then 3mm from solder joint to epoxy bulb, and soldering beyond the base of the tie bar is recommended.
|